How to Set the Travel Limits on a Genie Opener
Start with the door partway open. Hold the - button until the long LED turns blue, release, run the door down to closed, and press PRGM/SET. Then hold + until the long LED turns blue, release, run the door up to open, and press PRGM/SET. Finish with one full close and open from the wall button.
- Works for:
- Current Genie openers with a PRGM/SET button and + and - buttons on the motor unit. Older units set their limits differently; check the manual for the model on the label.
Written by the ClearTech Garage Doors team in Winnipeg and checked against manufacturer documentation. Updated .
Before you start
- A stepladder
- The door partway open, connected to the opener, and on normal power (not battery backup)
- A clear door path. The door moves during setup.
- A 2x4 board for the reversal test at the end
- Patience. Don't run the door from the wall button until both limits are set, or the opener can damage itself.
Step by step
Step 1: Closed position: press and hold - until the long LED turns blue, then release. The long LED flashes blue.
Step 2: Press and hold - to run the door down until it's fully closed and the bottom seal is pressed against the floor. Use + and - to fine-tune.
Each step has a 30-second window. If both LEDs turn red, start the step again.
Step 3: Press and release PRGM/SET. Both LEDs flash blue and go out.
Step 4: Open position: press and hold + until the long LED turns blue, then release. The round LED flashes blue.
Step 5: Press and hold + until the door is fully open, with the bottom of the door even with the top of the opening. Fine-tune with + and -.
Step 6: Press and release PRGM/SET. Both LEDs flash blue and go out.
Step 7: Use the wall button to close the door fully, then open it fully. The opener sets its force on this cycle.
Step 8: Lay a 2x4 flat on the floor under the door and close it. The door must reverse within two seconds of touching the board.
Still not working? Here is what it usually is.
- The door stops short or bounces back at the floor in winter. A frozen weather seal or ice on the floor changes where closed is. Clear it first.
- The opener strains or reverses partway. A weak or broken spring makes the door too heavy, and limits won't fix that.
- The limits won't save, which can point to a failing part on the motor unit.
We diagnose the whole system, opener, door, sensors, and remotes, and tell you plainly whether it's a quick fix or time for a new unit.
Sources
This guide was checked against the following manufacturer and industry documents.
More Genie guides
- Program a remotePair a new or replacement handheld remote.
- Program a keypadSet up an outdoor wireless keypad and PIN.
- Program your carPair HomeLink or the built-in buttons in your vehicle.
- Erase all remotesClear every paired remote after a move or a lost remote.
- Wi-Fi and app setupConnect the opener to your phone.
- Fix the safety sensorsDoor won't close, reverses, or the light blinks.
- What the flashing lights meanRead the opener's diagnostic codes.
- Battery backup beeps and lightsWhat the backup battery is telling you, and when to replace it.
- Replace a remote or keypad batteryWhich battery, how to open the case, and what to expect after.
- Lock out the remotesTurn vacation lock on and off from the wall control.
Ready to Book?
Same-day service across Winnipeg and nearby communities. Free on-site diagnosis on every residential repair.